LITHIUM BATTERY CHARGER
LITHICORE EDGE 2 CHARGER is compatible with the Following batteries
Lithum battery charger for all kind of batteries such as10440, 14500, 14650, 16340, 16650, 17650, 17670, 18350, 18490, 18500, 18650, 22650, 20700, 21700, 26500, 26650 Cylinder AA/AAA NiMH batteries and Nickel-Cadmium batteries.
Specifications:
Input and Output
Input: AC 100-240V 50/60Hz
Output: 4.2V/2A*1/2A*2 4.2V/1A*3/1A*4
LITHICORE EDGE 2 CHARGER – Charging features:
2.0A constant current charging: When one or two batteries are placed in any slots the charging current is 2A.
1.0A constant current charging: When three or four batteries are placed in the slots the charging current is automatically set to 1A.
Cut-off voltage for charging: 4.20 ± 0.05V
Cut-off current for constant voltage charging: <200mA
Input standby current: <40m A/100V-230V AC 50HZ/60HZ
Activation current (voltage <2.0V): 100mA-200mA
The quiescent current: within 100uA
0V activation function: Insert the low-voltage battery (battery voltage = 2.8V) within 5 minutes of the charger in standby mode, the charger will automatically recover the battery. Recovery time may vary depending on the discharge time and discharge level. Once the battery has recovered, the charging process will proceed normally.
Overcharge protection: If the batteries are fully charged and the charger is still connected to a power source, the charger will automatically stop charging.
Reverse polarity protection: While the charger is in standby mode, neither the positive nor negative poles can cause a short circuit to the slots or cause cross circuiting. If the batteries are placed in the slots in reverse, it will not cause damage to the batteries or charger.
LED display function: Each slot will display the charging status of the battery.
Description of the LED indication function:
The LED indications are:
1. Each slot displays 5 lights
2. Light will flash while charging
3. Light will stay on when battery is fully charged
4. All 5 lights will flash when charging is abnormal
When the EDGE 2 charger is connected to a power source, the system will begin self-detection and all of the LED indicators will light up. The charger will automatically enter standby mode after 1.5 seconds.
Please check battery specifications before use. The battery must be compatible with the EDGE 4 charger. Misuse can cause damage to the battery or the charger. Please do not attempt to charge incompatible batteries.
